Addressable Monitor Module
An addressable fire alarm system is made up of a series of fire detectors and devices that are connected back to a central control panel. With addressable systems, each device has an address or location, enabling the exact detector that was triggered to be quickly identified. This makes addressable alarm systems ideal for large buildings, particularly commercial premises spread over a wide area.
Features
- Connection of a zone of non-addressable detectors to an analogue addressable fire system
- Built in isolation allowing system installation in stages without loss of protection
- Monitors open circuit and short circuit faults
- TRI-Colour Status LED
- Zone powered from addressable loop wiring or external 24V PSU
- Remote reset of non-addressable zone
- Compatible with: Most non-addressable detectors IS non-addressable detectors
- Monitoring of external power supply
- External fault input
- CPD approval to EN54-17 and EN54-18, LPCB and VdS
- DIN rail mountable, consistent with all other modules
- Support for an extended power supply range as low as 18Vdc 60mA with an External PSU
Mechanical Specification
- Height: 23mm/li>
- Length: 93mm
- Width: 83mm
- Weight: 110g
- Max Wire Gauge for Terminals: 2
- Width: 83mm
Installation
- The MI-DCZRM addressable Zone Monitor module fits into M200E-SMB and M200E-DIN. Mounting hardware and installation instructions are provided with each Height: module.
Electrical Specification
- Operating Voltage Range: 18 to 28.5Vdc.
- Maximum Standby Current: 288µA maximum (conventional zone connected to external supply)
- LED Current
- Red: 2.2µA @ 24Vdc
- Green: 6.6µA @ 24Vdc
- Yellow: 8.8µA @ 24Vdc